Inverter batteries up to 2m el tape
No reward points for this product.
This inverter is capable of supporting 2m of el tape 1cm wide. It runs on 2 LR6 AA batteries and features a flashing mode.
Inverter 3 volts for el tape:
This inverter special el tape allows you to power up to 2m of el tape 1cm wide. It features a flashing function and is powered by 3 volts via 2 AA batteries.
The inverter is specifically adapted to strip lights that operate on the electroluminescence principle. By raising the frequency of the current from 50-60 Hertz to several hundred or even several thousand Hertz, light is created along the entire length of the el tape and over 360 degrees.
The advantages of electroluminescent lighting:
The el tape electroluminescent lighting emits no heat and adapts to your every need. It consumes 30 to 50% less energy than LEDs, 60 to 80% less than light bulbs and 90 to 99% less than conventional neon.
- Constant light over the entire length and 360 degrees
- No heat generation
- Very low power consumption (0.5 watts per meter)
- Flexible and highly resistant
- Waterproof
The cut parts are reusable, you just need to re-solder a connector.
Technical data from the inverter for el tape:
| Supported length of el tape: | 2 meters in 1cm width 2 x 1 meters in 1cm width (if you connect several bands on the same inverter) |
| Inverter: | 3 Volts via 2 AA batteries |
| Dimensions : | 88 mm x 33 mm x 19 mm |
| Functions : | ON / OFF / FLASHING |
Data sheet
- Inverter
- batteries
